- This product requires mask. KTM Mask or 850 Mask
- If you choose the KTM Mask Option you will receive a 1 yd roll of KTM if you order a 1 yard roll of pattern or will receive a 5 yd roll of KTM if you order a 5 yard roll of pattern.
- 11" printed workable space
- Matte finish
- We recommend if you use this product in a layered design to us this product as the top layer only.
- If ordering this product it may delay your standard shipping times depending on order value and time order was placed
- Please see our shipping policies
- May delay your order 1-3 business days; depending on the time the order is placed and the quantity.
- This is a Fargo only item, your entire order will ship from Fargo. Transit times may vary.
- This is a non-returnable product
- Colors are subject to change without notice
- This pattern is also availble in:
- Siser Vinyl
- Adheisve Vinyl
- Rhinestones
- Accessories
- Fashion Sign Vinyl Prints
Q&A
What color is the suicide awarness ribbon ?
Teal and Purple
What ribbon is used for suicide awareness ?
The Teal and Purple ribbon
- Cotton, Polyester, and 50/50: 266°F | Nylon: 302°F
- Cotton, Polyester, and 50/50: 5 seconds Nylon: Preheat for 5 seconds and press for 5 seconds. remove liner and cover with a teflon sheet and press for another 10 seconds
- Peel warm
- Medium, even pressure
- Cut right reading
- Cotton, Polyester, Uncoated Nylon, 50/50 blends
- Wash inside out. Tumble dry.
Additional Instructions
Cut your design right reading
Weed away excess material
Mask your design with a recommended mask
Remove the liner of the mask
Press your design at one of the temps and times listed above
Peel warm
CUT SETTINGS
Cut Settings for Graphtec CE6000:
Settings can alter for each cutter and how dull or sharp the blade is. Test Cutting is Recommended.
1. Offset: 0
2. Speed: 25 cm/s
3. Acceleration: 4
4. Cut Force: 16
*Heat Transfer Warehouse uses a 45 Degree Blade
Cut Settings for Silhouette Cameo:
Settings can alter on how dull or sharp the blade is. Test Cutting is Recommended.
1. Smooth Heat Transfer Material Setting
2. Blade at a 1
3. Speed at 5, Pressure at 6
4. Double Cut/Cut on Mat