• 311° F
• Preheat garment for 2-3 seconds. Press transfer at 15 seconds
• Peel Warm
• Medium, even pressure
• Cut in right reading
• 100% cotton, 100% light-colored polyester, Poly/cotton blends (not for dye sublimation fabrics)
• Wait 24 hours before the first wash, do not dry clean, max water temperature 160 °F, Dry on normal settings, so not use bleach

Additional Instructions

Additional Instructions Application instructions for dazzle cloth, shiny polyester materials, and coated polyester materials:

For the best vibrant prints, this material needs to be cured. To cure the material place the printed material on a warm platen and hover the platen over it at 311 degrees for 60 seconds without closing the press.

Damp a cloth with rubbing alcohol (isopropyl alcohol), then gently apply it to the area on the garment you want to apply your design. Allow it to dry and apply your material. This will allow the adhesive to better penetrate the garment.

We highly recommend that you wash and dry your garments prior to pressing your design. This will also allow the adhesive to better penetrate the garment. Cut Settings for Graphtec CE6000: Settings can alter for each cutter and how dull or sharp the blade is. Test Cutting is Recommended.

1. Offset: 0

2. Speed: 30 cm/s

3. Acceleration: 4

4. Cut Force: 8-9

*HTW uses a 45 Degree Blade

Cut Settings for Silhouette Cameo:

Settings can alter on how dull or sharp the blade is. Test Cutting is Recommended.

Material: Heat Transfer, Smooth

Blade: 3

Speed: 8

Force: 15

Cut Settings for Cricut®: Settings can alter on how dull or sharp the blade is. Test Cutting is Recommended. Set Material: Iron-On Pressure: Default Blade: Fine-Point Blade (Standard)