ThermoFlex Plus Metallics 12"

ThermoFlex Plus Metallics is a great soft hand feel product that gives your garments that metallic look without the stiffness!

• Flexible and gives a soft hand feel when pressed onto a garment
• Gives a strong grip when heat pressed onto a garment
• Will not adhere to nylon 
• Approximately 100 Microns thick
• Can only be used as a top layer
• Due to the manufacturing process, material may vary in width by 1/8-1/4"
• ThermoFlex Pantone Swatches
• Accessories
• Click here for ThermoFlex standard colors

• 330°F
• 15 seconds
• Peel warm or cold
• Medium, even pressure
• Cut in reverse
• Cotton, linen, wool, lyrca, polyester blends, and spandex
• Wait 24 hours before first wash. Wash warm, tumble dry on normal setting

Additional Instructions

Application instructions for dazzle cloth, shiny polyester materials, and coated polyester materials:

Damp a cloth with rubbing alcohol (isopropyl alcohol), then gently apply it to the area on the garment you want to apply your design. Allow it to dry and apply your material. This will allow the adhesive to better penetrate the garment.

We highly recommend that you wash and dry your garments prior to pressing your design. This will also allow the adhesive to better penetrate the garment.

Cut Settings for Graphtec CE6000:

 Settings can alter for each cutter and how dull or sharp the blade is. Test Cutting is Recommended.

1. Offset: 0

2. Speed: 25 cm/s

3. Acceleration: 4

4. Cut Force: 16

*HTW uses a 45 Degree Blade

Cut Settings for Silhouette Cameo:

Settings can alter on how dull or sharp the blade is. Test Cutting is Recommended.

Material: Heat Transfer, Smooth

Blade: 3

Speed: 8

Force: 6

Cut Settings for Cricut®:

Settings can alter on how dull or sharp the blade is. Test Cutting is Recommended.

Set Material: Iron-On

Pressure: Default

Blade: Fine-Point Blade (Standard)

• ThermoFlex Metallics PDF Application Instructions
• ThermoFlex Pantone Swatches