Transfer to Patch Instructions
- 390°F
- 60 seconds
- Peel Hot
- Medium pressure
Additional Instructions
The recommended settings above may need adjustments for best results. Settings vary depending on the heat press brand, model ink, paper, and atmospheric conditions.
When applying the transfer to the patch, use heat-safe tape. Do not use adhesive spray.
Steps:
1. Place a teflon sheet or scratch paper on bottom platen of your heat press
2. Position the transfer onto the patch
3. Use heat safe tape to keep the transfer in place on the patch. Only tape the edges to prevent the tape from sticking to the adhesive backing.
4. Place the taped transfer patch on your teflon/scratch sheet.
5. Cover the patch with a teflon sheet/scratch paper.
6. Press the items using the settings listed above.
7. Remove the transfer from the substrate and items from the heat press immediately. Use heat resisitant gloves if necessary - the items will be very hot.
Tips:
- If the image of the final product appears light, increase the pressure or time slightly (10-20 seconds).
- If the image on the final product appears blurred or substrate appears yellowed, reduce the time slightly (10-20 seconds).
When applying the pressed transfer to your garment, let your transfer sit for at least an hour.
Attach with a Heat Press Steps:
- Peel off paper backing
- 300 degrees for 15 seconds
- press from the front side of patch
Attach with a Heat Press Steps:
- Peel off paper backing
- 300 degrees (wool setting) for 15 seconds
- press from the back side of the fabric.
Care Instructions :
Patches can be dry cleaned or washed in a washing machine with cold water, air dry.
