• 311° F
• 10 - 15 seconds with 10 second re press if design lifts after initial press
• Peel Warm
• Medium pressure
• Cut in reverse
• 100% cotton, 100% polyester, Poly/cotton blends, leather
• Wait 24 hours before first wash. Machine wash warm or cold with mild detergent. Dry on normal dryer setting. Do not dry clean. 

Additional Instructions

Cut Settings for Graphtec CE6000:

Settings can alter for each cutter and how dull or sharp the blade is. Test Cutting is Recommended.

1. Gram Force: 10

2. Speed: 30 cm/s

3. Tool: CB09U+0

*Heat Transfer Warehouse uses a 45 Degree Blade

Cut Settings for Silhouette Cameo:

Settings can alter on how dull or sharp the blade is. Test Cutting is Recommended.

Material: Heat Transfer, Flocked

Blade: 4

Speed: 5

Force: 6

Cut Settings for Cricut®:

Settings can alter on how dull or sharp the blade is. Test Cutting is Recommended.

Set Material: Iron-On

Pressure: Default

Blade: Fine-Point Blade (Standard)

Cut Settings for Roland GS/GX-24:

Settings can alter on how dull or sharp the blade is. Test Cutting is Recommended.

Blade: 45 degree

Gram Force: 80-120

Offset: .250

Speed: 30 cm/s

Cut Settings for Scan N Cut:

Settings can alter on how dull or sharp the blade is. Test Cutting is Recommended.

Blade: Standard, 4

Cut Speed: 1 Cut

Pressure: 2

Cut Settings for Titan:

Settings can alter on how dull or sharp the blade is. Test Cutting is Recommended.

Blade: 45 degree / 60 degree

Gram Force: 100-110

Speed: 180 mm/s