12" Pricing:
50 Yard Roll: $307.00
*Please Note: All rolls are dropshipped from Indiana. 2-5 day ground service and $8.95 manufacturer shipping fee.
*If ordered as part of a larger order, this product will ship separately.
Face Film: 3.0 mil high gloss, intermediate calendered vinyl film
Adhesive Release: Aggressive, acrylic, permanent, pressure-sensitive. Not to be used with solvent based application fluids.
Liner: 78# (White) Bleached Kraft
Outdoor Durability: 6 years, mid-continental U.S., vertical.
Minimum Surface/Ambient Air Application Temperature: 35°F.
Application Surface: Interior and exterior markings/decals requiring low cost and flexible products. (e.g. original equipment markings)
Service Temperature Range: 50-150°F Reasonable range of temperatures, which would be expected under normal environmental time and temperature conditions.
Opacity: Normal
Typical Film Caliper (w/Adhesive): 3.8-4.2 mils
Chemical Resistance: Good for most petroleum solvents and lower aliphatic alcohols. For ultimate solvent resistance, edge sealing is recommended.
Water Resistance: Excellent: Test piece aged 24 hrs. after application to stainless steel panelbefore testing. Not affected when immersed in 70°F water for seven days.
Adhesion: 50 oz/in.
Shelf Life: 2 years when stored under conditions of 70°F and 50% relative humidity.
NOTE: Always pretest your specific substrates prior to actual application.
The above information on physical and chemical characteristics is based upon tests believed to be reliable. The values are intended only as a source of information. They are given without guarantee and do not constitute a warranty. The purchaser should independently determine, prior to use, the suitability of this material for his/her specific purpose. (Data represents averages and is not intended for use as a specification.)
1. Cut image in right reading
2. Weed material
3. Squeegee transfer mask over image
4. Remove the white backing (images will stick to the transfer mask)
5. Squeegee images onto surface
6. Remove transfer mask
Cut Settings for Silhouette Cameo:
Settings can alter on how dull or sharp the blade is. Test cutting is recommended.
1. Smooth Heat Transfer Material Setting
2. Blade at a 1
3. Speed at 3, Pressure at 4
Cut Settings for Graphtec CE6000:
Settings can alter for each cutter and how dull or sharp the blade is. Test cutting is recommended.
1. Offset: 0
2. Speed: 25 cm/s
3. Acceleration: 4
4. Cut Force: 16
*HTW uses a 45 Degree Blade
