• 305° F
• 10 - 15 seconds
• Peel hot or cold
• Medium pressure
• Cut in reverse
• Polyester, cotton, poly/cotton blends
• Wait 24 hours before first wash. Machine wash warm with mild detergent. DO NOT dry clean. NO bleach or fabric softener.

Additional Instructions

Additional Instructions Application instructions for dazzle cloth, shiny polyester materials, and coated polyester materials:

Damp a cloth with rubbing alcohol (isopropyl alcohol), then gently apply it to the area on the garment you want to apply your design. Allow it to dry and apply your material. This will allow the adhesive to better penetrate the garment.

We highly recommend that you wash and dry your garments prior to pressing your design. This will also allow the adhesive to better penetrate the garment. Cut Settings for Graphtec CE6000: Settings can alter for each cutter and how dull or sharp the blade is. Test Cutting is Recommended.

1. Offset: 0

2. Speed: 25 cm/s

3. Acceleration: 4

4. Cut Force: 16

*HTW uses a 45 Degree Blade

Cut Settings for Silhouette Cameo:

Settings can alter on how dull or sharp the blade is. Test Cutting is Recommended.

Material: Heat Transfer, Smooth

Blade: 3

Speed: 8

Force: 6

Cut Settings for Cricut®: Settings can alter on how dull or sharp the blade is. Test Cutting is Recommended. Set Material: Iron-On Pressure: Default Blade: Fine-Point Blade (Standard) Siser EasyWeed 15" PDF Instructions Siser EasyWeed Pantone Color Chart

• Use SiserPSV Application Tape Cut right reading Adheres to hard surfaces
• Cut image in right reading
• Weed material
• Squeegee transfer mask over image
• Remove the white backing (images will stick to the transfer mask)
• Squeegee images onto surface
• Remove transfer mask

Cut Settings for Graphtec CE6000:

Settings can alter for each cutter and how dull or sharp the blade is. Test cutting is recommended.

1. Offset: 0

2. Speed: 25 cm/s

3. Acceleration: 4

4. Cut Force: 16 *HTW uses a 45 Degree Blade

Cut Settings for Silhouette Cameo:

Settings can alter on how dull or sharp the blade is. Test Cutting is Recommended.

Material: Heat Transfer, Smooth

Blade: 1

Speed: 3

Force: 4

Cut Settings for Cricut®:

Settings can alter on how dull or sharp the blade is. Test Cutting is Recommended.

Set Material: Vinyl

Pressure: Default

Blade: Fine-Point Blade (Standard)